MoS2/SnS异质结太阳能电池的模拟研究

人工晶体学报 ›› 2021, Vol. 50 ›› Issue (3): 477-483.

MoS₂/SnS异质结太阳能电池的模拟研究

赵航航¹, 袁吉仁¹, 邓新华¹, 黄海宾²

1.南昌大学理学院,南昌 330031;
2.南昌大学光伏研究院,南昌 330031

收稿日期:2020-12-07 出版日期:2021-03-15 发布日期:2021-04-15
通讯作者: 袁吉仁,博士,副教授。E-mail:yuanjiren@ncu.edu.cn
作者简介:赵航航(1995—),男,江西省人,硕士研究生。E-mail:2416868335@qq.com
基金资助:
国家自然科学基金(11964018,11664025); 江西省自然科学基金(20181BAB202027)

Simulation of MoS₂/SnS Heterojunction Solar Cells

ZHAO Hanghang¹, YUAN Jiren¹, DENG Xinhua¹, HUANG Haibin²

1. School of Science, Nanchang University, Nanchang 330031, China;
2. Institute of Photovoltaic, Nanchang University, Nanchang 330031, China

Received:2020-12-07 Online:2021-03-15 Published:2021-04-15

摘要/Abstract

摘要： 硫化亚锡(SnS)是一种Ⅳ-Ⅵ族层状化合物半导体材料,其禁带宽度与太阳能电池最佳带隙1.5 eV非常接近,并且在可见光范围内光的吸收系数很大(α>10⁴ cm^-1),因此SnS是一种很有应用前景的材料。本文利用太阳能电池模拟软件wxAMPS模拟了MoS₂/SnS异质结太阳能电池,主要研究SnS吸收层的厚度、掺杂浓度和缺陷态等因素对太阳能电池性能的影响。研究发现:SnS吸收层最佳厚度为2 μm,最佳掺杂浓度为1.0×10¹⁵ cm^-3;同时高斯缺陷态浓度超过1.0×10¹⁵ cm^-3时,电池各项性能参数随着浓度的增加而减小,而带尾缺陷态超过1.0×10¹⁹ cm^-3·eV^-1时,电池性能才开始下降;其中界面缺陷态对太阳能电池影响比较严重,界面缺陷态浓度超过1.0×10¹² cm^-2时,开路电压、短路电流、填充因子和转换效率迅速下降。另外,通过模拟获得的转换效率高达24.87%,开路电压为0.88 V,短路电流为33.4 mA/cm²。由此可知,MoS₂/SnS异质结太阳能电池是一种很有发展潜力的光伏器件结构。

关键词: 硫化亚锡, MoS₂/SnS异质结太阳能电池, wxAMPS, 太阳能电池模拟, 缺陷态

Abstract: Stannous sulfide (SnS) is a class Ⅳ-Ⅵ layered compound semiconductor material. It's band gap is very close to the optimal band gap of 1.5 eV for solar cells, and the light absorption coefficient is very large (α>10⁴ cm^-1) in the visible light range, so it is a promising material for application. The MoS₂/SnS heterojunction solar cells were simulated by using the solar cell simulation software wxAMPS. The influence of SnS absorption layer thickness, doping concentration and defect states on the performance of solar cells were mainly studied. The results show that the optimal thickness of SnS absorption layer is 2 μm, the optimal doping concentration is 1.0×10¹⁵ cm^-3, and when the concentration of Gaussian defect states is more than 1.0×10¹⁵ cm^-3, the performance parameters of the cell decrease with the increase of concentration. However, when the concentration of tail defect states exceeds 1.0×10¹⁹ cm^-3·eV^-1, the performance of solar cell decreases. The interface defect states have obvious influence on the solar cell performance, when the concentration exceeds 1.0×10¹² cm^-2, the open circuit voltage, short circuit current, filling factor and conversion efficiency decrease rapidly. In addition, the optimal conversion efficiency is 24.87%, the open circuit voltage is 0.88 V, and the short circuit current is 33.4 mA/cm². It can be concluded that MoS₂/SnS heterojunction solar cell is a promising photovoltaic device structure.

Key words: SnS, MoS₂/SnS heterojunction solar cell, wxAMPS, solar cell simulation, defect state

中图分类号:

O474

赵航航, 袁吉仁, 邓新华, 黄海宾. MoS₂/SnS异质结太阳能电池的模拟研究[J]. 人工晶体学报, 2021, 50(3): 477-483.

ZHAO Hanghang, YUAN Jiren, DENG Xinhua, HUANG Haibin. Simulation of MoS₂/SnS Heterojunction Solar Cells[J]. JOURNAL OF SYNTHETIC CRYSTALS, 2021, 50(3): 477-483.

参考文献

[1] TAKEUCHI K, ICHIMURA M, ARAI E, et al.SnS thin films fabricated by pulsed and normal electrochemical deposition[J]. Solar Energy Materials and Solar Cells, 2003, 75(3/4): 427-432.
[2] CHO J Y, SINHA S, GANG M G, et al.Controlled thickness of a chemical-bath-deposited CdS buffer layer for a SnS thin film solar cell with more than 3% efficiency[J]. Journal of Alloys and Compounds, 2019, 796: 160-166.
[3] YUE G H, WANG W, WANG L S, et al.The effect of anneal temperature on physical properties of SnS films[J]. Journal of Alloys and Compounds, 2009, 474(1/2): 445-449.
[4] VOZNYI A, KOSYAK V, YEROMENKO Y, et al.Close-spaced sublimation of SnS absorber layers and SnS/CdS heterojunction solar cells with Mo and Ti back metal contacts[J]. Thin Solid Films, 2020, 709: 138153.
[5] FATHY M, ELYAMNY S, BISHARA A A, et al.SnS nanocrystalline thin films for n-CdS/p-SnS solar cell devices[J]. Journal of Materials Science: Materials in Electronics, 2020, 31(20): 18120-18134.
[6] MINBASHI M, GHOBADI A, EHSANI M H, et al.Simulation of high efficiency SnS-based solar cells with SCAPS[J]. Solar Energy, 2018, 176: 520-525.
[7] SHASHIDHAR R, CHOUDHARY N.Cost-effective SnS heterojunction solar cells synthesized by spray pyrolysis[J]. Journal of Sol-Gel Science and Technology, 2020, 96(1): 188-196.
[8] CHERAGHIZADE M, JAMALI-SHEINI F, SHABANI P.Charge transportation mechanisms in TiO₂/SnS/Ag solar cells[J]. Materials Research Bulletin, 2020, 124: 110727.
[9] JEONG D S, REDDY V R M, PALLAVOLU M R, et al. Investigation on the performance of SnS solar cells grown by sputtering and effusion cell evaporation[J]. Korean Journal of Chemical Engineering, 2020, 37(6): 1066-1070.
[10] BERNARDI M, PALUMMO M, GROSSMAN J C.Extraordinary sunlight absorption and one nanometer thick photovoltaics using two-dimensional monolayer materials[J]. Nano Letters, 2013, 13(8): 3664-3670.
[11] HAO L Z, LIU Y J, GAO W, et al.Electrical and photovoltaic characteristics of MoS₂/Si p-n junctions[J]. Journal of Applied Physics, 2015, 117(11): 114502.
[12] HAO L Z, GAO W, LIU Y J, et al.Self-powered broadband, high-detectivity and ultrafast photodetectors based on Pd-MoS₂/Si heterojunctions[J]. Physical Chemistry Chemical Physics, 2016, 18(2): 1131-1139.
[13] 罗伟,姜鑫,梁世豪,等.基于AFORS-HET的单层MoS₂(n)/a-Si(i)/c-Si(p)/μc-Si(p+)异质结太阳能电池模拟[J].人工晶体学报,2020,49(3):422-427.
LUO W, JIANG X, LIANG S H, et al.Simulation of single layer MoS₂(n)/a-Si(i)/c-Si(p)/μc-Si(p+) heterojunction solar cells based on AFORS-HET software[J]. Journal of Synthetic Crystals, 2020, 49(3): 422-427(in Chinese).
[14] 刘一鸣, 孙云, ANGUS R.新型太阳能电池模拟软件—wxAMPS[C].中国光伏大会暨国际光伏展览会,2012.
LIU Y M, SUN Y, ANGUS R.New solar cell simulation software-wxamps[C]. China Photovoltaic Conference and International Photovoltaic Exhibition, 2012.
[15] CHAUDHARY R, PATEL K, SINHA R K, et al.Potential application of mono/bi-layer molybdenum disulfide (MoS₂) sheet as an efficient transparent conducting electrode in silicon heterojunction solar cells[J]. Journal of Applied Physics, 2016, 120(1): 013104.
[16] MINNAM REDDY V R, GEDI S, PARK C, et al. Development of sulphurized SnS thin film solar cells[J]. Current Applied Physics, 2015, 15(5): 588-598.
[17] KEARNEY K L, ROCKETT A A.Simulation of charge transport and recombination across functionalized Si(111) photoelectrodes[J]. Journal of the Electrochemical Society, 2016, 163(7): H598-H604.
[18] FONASH S J.Surface-barrier solar cells[M]//Solar Cell Device Physics. Amsterdam: Elsevier, 2010: 263-294.
[19] RANA T R, KIM S, KIM J.Existence of multiple phases and defect states of SnS absorber and its detrimental effect on efficiency of SnS solar cell[J]. Current Applied Physics, 2018, 18(6): 663-666.

MoS₂/SnS异质结太阳能电池的模拟研究

Simulation of MoS₂/SnS Heterojunction Solar Cells

PDF (PC)

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 3

编辑推荐

Metrics

本文评价

[1]	张俊峰;吴隽;龙晓阳;祝柏林;李涛涛;姚亚刚. O2/(O2+Ar)流量比对ZnO-0.25mol; V2O5薄膜缺陷类型的影响[J]. 人工晶体学报, 2017, 46(4): 651-656.
[2]	王马华;朱汉清;朱光平. 电化学沉淀法制备纳米结构氧化锌的场发射特性[J]. 人工晶体学报, 2011, 40(1): 187-192.
[3]	郭余英;史伟民;魏光普;夏义本. 衬底温度对SnS薄膜性能的影响[J]. 人工晶体学报, 2008, 37(3): 666-669.