欢迎访问《人工晶体学报》官方网站,今天是 分享到:

人工晶体学报 ›› 2021, Vol. 50 ›› Issue (7): 1378-1385.

• 研究论文 • 上一篇    下一篇

单面柱局域共振声子晶体低频带隙特性分析及结构改进研究

孙向洋1, 燕群1, 郭翔鹰2   

  1. 1.中国飞机强度研究所,航空声学与动强度航空科技重点实验室,西安 710065;
    2.北京工业大学机械工程学院,机械结构非线性振动与强度北京市重点实验室,北京 100124
  • 收稿日期:2021-04-23 出版日期:2021-07-15 发布日期:2021-08-16
  • 作者简介:孙向洋(1992—),男,陕西省人,助理工程师。E-mail:867948451@qq.com
  • 基金资助:
    航空科学基金(20200015023003)

Characteristic Research of Low Frequency Band Gaps and Structural Improvement in Single-Sided Column Local Resonance Phononic Crystals

SUN Xiangyang1, YAN Qun1, GUO Xiangying2   

  1. 1. Key Laboratory of Aeronautical Acoustics and Dynamic Strength Aviation Science and Technology, AVIC Aircraft Strength Research Institute, Xi’an 710065, China;
    2. Beijing Key Laboratory of Nonlinear Vibrations and Strength of Mechanical Structures,College of Mechanical Engineering, Beijing University of Technology, Beijing 100124, China
  • Received:2021-04-23 Online:2021-07-15 Published:2021-08-16

摘要: 基于有限元法对单面柱局域共振声子晶体进行带隙特性分析,研究了结构参数对该类型声子晶体的影响。结果表明:随着散射体高度的增加,单面柱声子晶体的第一完全带隙的起始频率逐渐降低,带宽逐渐增大;随着基板厚度的增大,单面柱声子晶体的起始频率逐渐升高,截止频率先增大后减小。并且在经典单面柱声子晶体的基础上,组合了两种新型的三组元单面柱声子晶体结构:嵌入式单面柱声子晶体(以下简称结构Ⅰ)和粘接式单面柱声子晶体(以下简称结构Ⅱ)。通过对其带隙特性的分析得出:这两种新结构与经典的单面柱声子晶体相比,都具有更低频的带隙,这对于低频减振降噪是非常有利的。本文的结果将对实际的工程应用提供一定的理论指导。

关键词: 单面柱声子晶体, 有限元法, 散射体, 带隙, 低频减振降噪

Abstract: Based on the finite element method, the band gap of the phononic crystal in single-sided cylinder local resonance was analyzed, and the influence of structural parameters on the phononic crystal was studied. The results show that the initial frequency of the first complete band gap decreases and the bandwidth increases with the increase of the height of the scatterer. With the increase of the thickness of the substrate, the initial frequency of the single-sided cylindrical phononic crystal increases gradually, the cut-off frequency first increases and then decreases. In addition, based on the classical single-sided cylindrical phononic crystal, two new ternary single-sided cylindrical phononic crystal structures are combined: embedded single-sided cylindrical phononic crystal (Hereinafter referred to as structure Ⅰ) and bonded single-sided cylindrical phononic crystal (Hereinafter referred to as structure Ⅱ). Through the analysis of the band gap characteristics, it is concluded that the two new structures have lower frequency band gap compared with the classical single-sided cylindrical phononic crystals, which is very beneficial for low-frequency vibration and noise reduction. The results of this paper will provide some theoretical guidance for practical engineering application.

Key words: single-sided cylindrical phononic crystal, finite element method, scatterer, band gap, low-frequency vibration and noise reduction

中图分类号: