欢迎访问《人工晶体学报》官方网站,今天是 分享到:

人工晶体学报 ›› 2023, Vol. 52 ›› Issue (11): 1980-1988.

• 研究论文 • 上一篇    下一篇

高温退火Cu (111)衬底上生长高质量厘米尺寸单晶石墨烯

祁建海1,2, 陈洋1,2, 岳圆圆3, 吕炳辰1,2, 程宇昂1,2, 朱凤前1,2, 贾玉萍1,2, 李绍娟1,2, 孙晓娟1,2, 黎大兵1,2   

  1. 1.中国科学院长春光学精密机械与物理研究所,发光及应用国家重点实验室,长春 130033;
    2.中国科学院大学,材料科学与光电工程中心,北京 100049;
    3.吉林财经大学管理科学与信息工程学院,长春 130117
  • 收稿日期:2023-04-13 出版日期:2023-11-15 发布日期:2023-11-17

Growth of High-Quality Centimeter-Size Single-Crystal Graphene on High-Temperature Annealed Cu (111) Substrate

QI Jianhai1,2, CHEN Yang1,2, YUE Yuanyuan3, LYU Bingchen1,2, CHENG Yuang1,2, ZHU Fengqian1,2, JIA Yuping1,2, LI Shaojuan1,2, SUN Xiaojuan1,2, LI Dabing1,2   

  1. 1. State Key Laboratory of Luminescence and Applications, Changchun Institute of Optics, Fine Mechanics and Physics, Chinese Academy of Sciences, Changchun 130033, China;
    2. Center of Materials Science and Optoelectronics Engineering, University of the Chinese Academy of Sciences, Beijing 100049, China;
    3. School of Management Science and Information Engineering, Jilin University of Finance and Economics, Changchun 130117, China
  • Received:2023-04-13 Online:2023-11-15 Published:2023-11-17
  • Contact: CHEN Yang, associate researcher. E-mail: cheny@ciomp.ac.cn;SUN Xiaojuan, researcher. E-mail: sunxj@ciomp.ac.cn
  • About author:QI Jianhai (1995—), male, from Jiangsu Province, master. E-mail: 2603591798@qq.com
  • Supported by:
    National Key R&D Program of China (2021YFB3601600); National Natural Science Foundation of China (61827813, 52002368, 62121005, 62074147, 62022081, 61974099); Natural Science Foundation of Jilin Province (20230101345JC, 20230101107JC, 20230508132RC); Youth Innovation Promotion Association of the Chinese Academy of Sciences (Y201945, 2019222)

摘要: 二维(2D)石墨烯具有原子层厚度,在电子器件中展示出突破摩尔定律限制的巨大潜力。目前,化学气相沉积(CVD)是一种广泛应用于石墨烯生长的方法,满足低成本、大面积生产和易于控制层数的需求。然而,由于催化金属(例如Cu)衬底一般为多晶特性,导致CVD法生长的石墨烯晶体质量相对较差。为此,通过高温退火工艺制备了Cu (111)单晶衬底,使石墨烯的初始成核过程得到了很好的控制,从而实现了厘米尺寸的高质量单晶石墨烯的制备。根据二者的晶格匹配关系,Cu (111)衬底为石墨烯生长提供了唯一的成核取向,相邻石墨烯成核岛的边界能够缝合到一起。单晶石墨烯具有高电导率,相较于原始多晶Cu上生长的石墨烯(1 415.7 Ω·sq-1),其平均薄层电阻低至607.5 Ω·sq-1。高温退火能够清洁铜箔,从而获得表面粗糙度较低的洁净石墨烯。将石墨烯用于场效应晶体管(FET),器件的最大开关比为145.5,载流子迁移率为2.31×103 cm2·V-1·s-1。基于以上结果,相信本工作中的单晶石墨烯还满足其他高性能电子器件的制备。

关键词: Cu (111), 石墨烯, 高温退火, 化学气相沉积, 场效应晶体管

Abstract: Two-dimensional (2D) graphene has shown great potential of breakthrough of Moore's law limitation due to its atomic thickness in electronic devices. Up to now, chemical vapor deposition (CVD) is a widely applied method for graphene growth due to its low-cost, large-area production, and easy control in layer number. However, the CVD-grown graphene usually suffers from relatively low quality derived from the polycrystalline nature of catalytic metal (e.g., Cu) substrates. Herein, single-crystal Cu (111) substrates were fabricated by a high-temperature annealing process, initial nucleation of graphene on it has been well controlled, and high-quality and centimeter-size single-crystal graphene was achieved. The Cu (111) substrate provides onefold orientation for the graphene growth according to their lattice matching relation, and domain boundaries of neighboring graphene nuclei could stitch together. The as-grown single-crystal graphene has an average sheet resistance of 607.5 Ω · sq-1. Compared to that of grown on the pristine polycrystalline Cu (1 415.7 Ω · sq-1), it shows high electrical conductivity. High-temperature annealing purified the Cu foils, and induced a clean graphene surface with lower roughness. The quality of graphene is further verified by using it in a field-effect transistor (FET), resulting in a maximum switch ratio of 145.5 and carrier mobility of 2.31×103 cm2 · V-1 · s-1. Based on these results, we believe that the single-crystal graphene in present work is also feasible for fabricating other high-performance electronic devices.

Key words: Cu (111), graphene, high-temperature annealing, chemical vapor deposition, field-effect transistor

中图分类号: